Cut the trim pieces.
Make a barn door out of plywood.
If your plywood has one side that looks nicer than the other choose which side you.
The ones we used and the ones i wish we had purchased.
Using your level check that the track and your mounting board are level and mark where each hole will be drilled.
Step 3 cut two 1 inch by 4 inch planks to the width of the door with a miter saw.
The 1 x 4s will be used on the diagonals and to frame out the outside of the door.
Once the edges have been.
If you hardware kit didn t come with stoppers we recommend adding one stop.
Frame of mind since a flat piece of plywood would make for a pretty boring sliding door you re going to want to purchase some 1 x 4s and a 1 x 6 to create a barn house effect on your door.
Once the pieces have been cut sand down the edges.
How to build a sliding barn door cut plywood to the size of the door frame.
Here are the materials we used.
With help lift the barn wood door and roll it onto the track.
Drill your holes to attach track to the wall.
I m wrapping up a project for a client an.
Place the cut plywood up to the door.
3 4 plywood for the back of the doors 1 x6 boards for the top and bottom trims 1 x4 boards for remaining trim 10ft barn door track kit listing has other sizes 10 inch black steel door handle.
This includes the hardware and track.
Cut a sheet of 3 4 plywood to the size of your door opening plus the trim.
Once i had the whole thing assembled i measured and drilled the holes for the barn door hardware.
Hold the cut sheet of plywood in place over the opening to verify the measurements.
Place the sheet of plywood on the sawhorses.
If you want to cover the opening with one door you ll need an area on one side of the opening that s wide enough for the door.
Mark the measurements for the door on the sheet of plywood.
Choose which side will be the front.
Cut the door out of the plywood using a circular saw.
In this video i ll show you how to build a wooden barn door for under a 100.
The 1 x 6 will serve as the horizontal middle of the door.
You can t even tell that the door is made from plywood.
Mark any adjustments needed onto the wood and cut with a circular saw.